A static route needs to be configured on Router1. This is because the network segment 192.168.4.0/24 is invisible to Router1. In this network, for Router1, the network segment 192.168.2.0/24 and the network segment 192.168.3.0/24 belong to the directly connected network segment for Router1, which means that for PC-A, the access network segment 192.168.2.0/24 There is no problem with the network segment 192.168.3.0/24, but the network segment 192.168.4.0/24 cannot be accessed.

Next, you need to configure the global configuration file for hostapdĪssuming that there is such a network topology, Router1 and Router2 in the figure are our development board devices, and the running system is the Ubuntu operating system. If more automated and tight configuration of these wireless parameters is required, the OpenWRT softrouting system can be used instead of the Ubuntu system. The modes supported by hw_mode include a, g, channel channels are related to hw_mode, country_code, etc. Wpa_passphrase: Wireless AP password, here is set to 12345678įor more information, the configuration of nf is undoubtedly very complicated. Ssid: wireless AP name, here set Example-Wifi-Name Interface: enable the wireless network card of the wireless AP hotspotīridge: bind to the br0 bridge, so that the wireless AP hotspot and the Ethernet port are in the same LAN Introduction to Yocto Project Release layerĬhannel = 11 macaddr_acl = 0 auth_algs = 1 ignore_broadcast_ssid = 0 wpa = 2 wpa_passphrase = 12345678 wpa_key_mgmt =WPA-PSKĬountry_code: country code, China uses CN Use root to log in to the system interface Configure IP address and routing using ip and netplan

Install the necessary software packages for managing AP hotspots There are requirements for the IP LAN segment of the wireless hotspot There is no requirement for the IP LAN segment of the wireless hotspot Ethernet port general parameter configuration

Free for mac instal Hotspot Maker 3.2